Search found 13 matches
- Sat Dec 30, 2023 4:28 pm
- Forum: General Discussions
- Topic: version 1.00.76 Fenix
- Replies: 0
- Views: 2256
version 1.00.76 Fenix
Flying at EGLL that has both ILS and RNAV approaches. I understand that FSIPANEL selects the ILS approach and that can be changed in the flight plan , to the RNAV approach, before you take control of the Aircraft. Then you fly the RNAV approach and land. You then want to do the same approach again. ...
- Tue Nov 21, 2023 6:10 pm
- Forum: General Discussions
- Topic: Does not prompt for brakes 3 second
- Replies: 3
- Views: 735
Re: Does not prompt for brakes 3 second
FENIX AND TRIED IT SEVERAL TIMES. It did work on long final
- Sat Nov 18, 2023 8:20 pm
- Forum: General Discussions
- Topic: Does not prompt for brakes 3 second
- Replies: 3
- Views: 735
Does not prompt for brakes 3 second
Flying an RNAV 29L at airport KFAT.
I set a waypoint at IPUJE, with offset at 5 NM.
The aircraft moves and prompted to move levers to climb.
Never get a prompt for applying brakes for 3 second and aircraft descends and crashes.
I set a waypoint at IPUJE, with offset at 5 NM.
The aircraft moves and prompted to move levers to climb.
Never get a prompt for applying brakes for 3 second and aircraft descends and crashes.
- Mon Jul 17, 2023 5:30 pm
- Forum: General Discussions
- Topic: Having many issues with FSIPANEL and Fenix
- Replies: 4
- Views: 712
Having many issues with FSIPANEL and Fenix
Up to this point it seemed like all was working as expected, but recently I am seeing issues when you try to retry an approach after the first attempt. I have seen where the aircraft goes into alpha floor, and never comes out of that state. The message does not show the hold brake for 3 seconds in t...
- Fri Jul 14, 2023 6:41 pm
- Forum: General Discussions
- Topic: fENIX A320 doing multiple approaches
- Replies: 2
- Views: 442
Re: fENIX A320 doing multiple approaches
yes JP also performance page is empty along with the init page 2
I also noticed that if I try multiple approaches, after resetting the ZFW and performance page, at some point the Fenix fails with elevation fault and no flight plan in the MCDU, after FSIPANEL says hold brakes for 3 seconds.
I also noticed that if I try multiple approaches, after resetting the ZFW and performance page, at some point the Fenix fails with elevation fault and no flight plan in the MCDU, after FSIPANEL says hold brakes for 3 seconds.
- Thu Jul 13, 2023 2:09 pm
- Forum: General Discussions
- Topic: fENIX A320 doing multiple approaches
- Replies: 2
- Views: 442
fENIX A320 doing multiple approaches
It seems like after you do an ILS Approach, and try to do another one you have to setup the MCDU INIT B again. Am I missing something?
- Wed Jul 05, 2023 9:04 pm
- Forum: General Discussions
- Topic: KMIA RWY 09
- Replies: 0
- Views: 1683
KMIA RWY 09
For some reason I start out on runway 09, but FSI Panel programs an ILS Runway 08
- Fri Jun 30, 2023 6:02 pm
- Forum: General Discussions
- Topic: Radio callouts
- Replies: 3
- Views: 444
Re: Radio callouts
You have to have radio tuned to get the 50, 40 , 30 callouts? I get callouts for radar altimeter then callouts to minimum, but never the callouts below that. I did tune radio, no changes. I just tried an AutoLand and I got the callouts so maybe something you must not do when you do not fly an AutoLa...
- Fri Jun 30, 2023 4:39 pm
- Forum: General Discussions
- Topic: Radio callouts
- Replies: 3
- Views: 444
Radio callouts
It seems like when I fly using FSIPANEL, I am not getting radio callouts when flying approaches in the FENIX. Not sure what is going on? When I fly normal flights they work
- Thu Jun 29, 2023 2:22 pm
- Forum: General Discussions
- Topic: Fenix flying ILS
- Replies: 3
- Views: 457
Fenix flying ILS
When you do a long final, using an ILS, it is my understanding all you have to do is go to the EFB and remove chalks and GPS and go to Mass and Balance and setup an amount of fuel etc... I thought FSI panel would then set the MCDU ZFW/CG for you, but seems you have to manually do this? It also seems...