FSiPanel forums

Hi FSI Panel was working fine but the flybywire team have now split off development of A320 into a separate plane within MSFS2020. When I tried to use this new modded plane with your software it did not work as it did previously. Is this something you are aware of and can it be fixed if it is a problem rather than me being the problem.
Thanks
Phil

Hi,

Thanks for the information, I was not aware of this new development.
I will check it and report back here.

Cheers,

J-P

Hi again,

Which version did you install? Stable 0.5.4 ?

Hi
I am now using the experimental build version (FBW version) although I think all of them are now separated out as new airliner in MSFS2020.
This worked fine before it was branched off as separate plane within MSFS2020.
So this appears as new airliner in sim.
Anything you can do would be great.
Thanks
Phil

Ah ok I see.
This experimental version is using non standard variables for the FCU / Autopilot.

I will need to get more information from FBW to make it compatible.

Regards,

J-P

Hi, in hte DEV version i think it's the same. It's a separate Aircraft now. Only the Stable ist the moded A320Neo. ?!?

regards Peter

Hi,

FlyByWire have just updated their installer, and the new Mod version is now v0.6.0. The next couple of days I will poke around in the Stable version to see what is included. If some of the advanced features are still now available in the Stable version I will resort back to the Experimental version

Ill check the MSFS A320 and the spin off FlyByWire A320 as well.

Dave

Hi As there been any more updates to the FSI panel software, as the current Flyby wire 'Development version' constantly 'nose-dives' into the ground.

Thanks,
mike

Thanks,
received email to say this is work in progress and is being worked on.