FSiPanel forums

Hi, I’m new to FSI Panel and I can’t figure out how to use the training feature. If it’s about trying some approach, no problem, but when it has to load a training session, nothing happens.

I'm tryining with Fenix A320. I’ve downloaded the training sessions and selected the WH preset. I’m on the runway with the engines running, as required by the prerequisites, but when I try to start the session, I only get an ATC message. I close the ATC message and wait, but nothing happens.

Yesterday I tried positioning the aircraft myself at the waypoint mentioned in the training description, and that worked. However, for something like the London Tour, I just can’t get it to start. The ATC message shows up, but then I stay on the runway with nothing happening.

Hi,

London tour is a old scenario and I guess it has an issue.
I will check it out to see if it can be fixed or remove it from the list.

Were you able to complete a training scenario ?

Best is to start from the latest on the list and to go up, this will ensure airac matches the scenario.

Cheers,

J-P

Yes, the latest works fine, thank you

Hi,

I have the same exact problem on MSFS 2024 and Fenix A320.
I tried 2 scenarios - 'rainy day in Manchester' and 'Tivat circling approach', which both failed as explained above.
I understand these might be old, but, just in case, here is what I have in the log file in both cases: "error loading snapshot : La référence d'objet n'est pas définie à une instance d'un objet."

I hope this helps solve the issue, as I really enjoy FSIPanel scenarios (albeit I have only been able to use the ones which start on the ground).

Thank you,

Renaud