FSiPanel forums

I have never had this problem. When i set up a scenario, specifically a RNP RNAV approach. When it says Hold brakes for 3 seconds, it automatically turns the flight over to me with no pressing of the brakes so I am unable to set other parameters. Any idea what could be the cause. Never experienced this until now. Thanks.

Hi,

Thanks for your message!

Did you have parking brake ON when pushing MOVE AC?
Any joystick axis, buttons assigned to brakes maybe?

During the trimming phase, can you have a look at your brake pedals, are they pushed ?

Cheers,

J-P

J-P at some point it does appear that my brakes got set somehow, whatever i did. I had to do some resets in my saved state for FSIPanel and it seems to have solved the problem. I had checked it one time and when i pressed move A/C they were not set but it was reading that they were. I will try a few more scenarios and be sure the problem is solved. Thanks so much for your time Sir.

DCR