FSiPanel forums

Hello All

I bought FSIpanel a few days a go, and it is a great tool to test my skills and failure solving in various aircraft ( RW A320/A330 pilot ).

I tried to program an Engine Failure No Damage at V1 with the A320 Fenix Aircraft, ( ENG R FAIL +135 Kts ) FSIpanel doesnt set the failure right away ( like it does in the PMDG B737 ). It only starts to program the failure when the aircraft goes through 80 Kts, and fails the engine way before the 135Kts ( at around 110kts all the time ).

I tried setting the same failure directly in the FMGS and I works just fine, so mayby something is happing between the way FSipanel talks and reads the Fenix A320 in the sim.

Kind Regards

Hi, Thanks for the information, bug is confirmed.
I have updated recently the 737 for precise IAS trigger for V1Cut training, this change was not uplodaded to the FENIX.

I have corrected it and will push an update probably today.

Many thanks for this finding!

Cheers,

J-P

Hello

Thanks for taking a look into it. By the way the same thing happend on the Leonardo Maddog.

Cheers