FSiPanel forums

Hi,

Flying this scenario using PMDG 737 and encountering the following problems:

1. If I choose 'say again' option, voice repeats ATC message and screen panel with ATC text appears. However, there appears to be no way of closing the screen panel and no further communication with ATC is possible with the screen panel open.

2. Whilst descending to LIMJ minimums there appears to be no way of informing ATC of a go-around as suggested in the instructions for the scenario.

3. After executing a missed approach, there is no further communication from LIMJ Tower with further instructions.

Aside from these issues, I think the scenario is great:)

Any advice?

Renzo

Hi Renzo, did you execute the MAP at minimum?
Then you just need to transmit to tower, saying go-around to get further instructions.

Which ATC message did you request with SAY Again that was not going away?

Regards,

J-P

I uninstalled and reinstalled FSI Panel and I think that has solved the issue.

I now get an acknowledgement of my MAP on my way to the holding point. There is no further ATC instruction from this point which I assume is intended. So I made my own way to LIMC for a CAT2/3 landing.

Thanks for reply

Renzo