Fenix A320 IAE Will Not Setup Correctly

[Mandretti]

I am setting up for a long final ILS approach at LAX. I have the FSIP configuration such that it is managing weight, MCDU etc typing speed slow. The AC is on the runway, in ready state, engines operational. I click Move AC and the process starts. I move the thrust levers to CLB and the panel shows I'm in CLB mode. FSIP starts working, but at some point along the way the aircraft starts descending, and thrust increases so that shortly I'm overspeed. I move the thrust levers around a bit, make sure I'm in the climb detent. But it continues to descend and eventually crashes. It never releases the aircraft for my control. Tried many times with the same result.

Thanks.

[tcas76]

Good evening,
I Think I’m experienceing the same difficulties with the CFMN version of the Fenix.

I want FSI Panel to set me up on a right downwind at LPPT

ISPßß.png

In sthe sim the autopilot reads 400 as speed and an altitude of 12500 ft.

I can never take over, it just crashes into the ground.

ISP 01.png

Her's my troubleshooting page:

FSP 02.png

FSI PAnel works for the Maddog and the PMDG.

Thanks ind avance,

Markus

[tcas76]

I forgot to post you my Fenix settings, sorry

FSP 03.png

Thank you,

Markus

[jpgarraio]

Hi,

Ok I see that speed setting as well as alitude on the FCU is wrong.
We have updated the processes to set FCU on the latest version of FSiPanel based on Fenix latest version.

It seems that you are not flying the latest version of the Fenix A320? reason why the altitude and speed are wrong.

Can you check which Fenix version you're flying and report back.

Regards,

J-P

[tcas76]

Good morning,

it's 2.0.0.407 that I'm using.

I tried to reinstall FSIparnel as well, unfortunately with the same result.

Thanks for your help,

Markus

[tcas76]

Good evening,

I deleted rhe Fenix Airbus and did a reinstall.

I also deleted FS2Crew because firstly I didn't get it work correctly with speech recognition, and second because with it I first saw a speed of 400 displayed in the FCU.

Now everything works again as it should, thanks for your help,

Markus