PMDG 738 drifting off before pilot taking control

[shapke]

Hi, when I position the PMDG 738 for an approach, it starts to drift off before I take control (i.e. apply brakes for 3 sec). When I am in the Fenix A320, everything works fine and the aircraft is regularly reset to the desired initial position until I take over control. Am I missing something with the PMDG 738?

[jpgarraio]

Hi,

Normally the 737 should be in position freeze until you take control.
Could you check that your parking brake is off when you click MOVE AC.

Regards,

J-P

[shapke]

Thanks, JP,

I confirm the parking brake is off. So, overall, the aircraft is still frozen, but it is drifting away with the wind. I have no problems with the Fenix A320, but my PMDG 738 doesn’t maintain its position.

[jpgarraio]

very strange, the only reason is if you took the controls.
Did you get a message from FSiPanel, "You have control" ?

[shapke]

No, I did not get that message.

[jpgarraio]

do you see the window with FSiPanel instructions on your screen?
Also saying settings flaps, etc ?

[shapke]

Hi JP,

I tried again, didn't change anything with the configuration of the plane or my procedures, and now it seems to work. Sorry if I caused any inconvenience. Let's close this thread now, I am sure it will work now.

In any case, thanks a lot for your great work and your commitment. FSiPanel is by far one of the best tools out there!