Fenix A320 B2 Issues

[Mandretti]

I'm setting to practice landing at KDEN RW08, sitting on the runway, panel state set to ready. I set Move AC to the long final setting. I get the Put your throttle in climb detent msg which I do. It then appears to do not much of anything for 5 minutes. Then says everything is ready, but clearly not ready. Just sits on the runway. Finally gets up in the air, then works for another 3-4 minutes before I get the hit the brakes msg. AP is off and won't connect. ILS is not set up. I restart the scenario with FSIPanel after landing failure. Another 5 minutes says everything is ready but I'm directly over the runway about 3 thousand feet in the air. The 3-4 minutes later I'm at14,000 ft and climbing. It's been trying to set up for 8 minutes now with no success.

Now its got me at 90 kts, at 16K feet, climbing rapidly and saying Hold your brakes for 3 seconds. Don't think that's going to work

I've restarted the flight, restarted the sim, rebooted the PC with same result.

I'm on the latest fSIP update, and I'm current with the A320 version.

[Pedro100]

The same Problem

[jpgarraio]

Hi,

This issue is if your thrust levers are not perfectly set in CLB or if you did not restart MSFS after the WASM module was installed by FSiPanel.
Do you still have it ?

regards,

J-P